[Interest] Problem with QTcpSocket and Windows 7
pritam_ghanghas at infosys.com
Thu May 10 14:22:21 CEST 2012
Without code its difficult to tell.
My best guess:
Most likely the code that watches over the network connection state is
I dont remember any API in qt that does that. So this may be platform
specific code in your application.
On Thursday 10 May 2012 05:38 PM, Lucas.Betschart at crypto.ch wrote:
> Hello Qt People,
> Maybe this is not a Qt specific question, but maybe someone has an
> idea or had a similar problem.
> I got a Services running under Windows (till now XP) which connects to
> our device through Telent/TCP.
> On Windows XP the services reconnects automatically after a disconnect
> (plug cable out), but on Windows 7 it doesn't.
> I have checked the sources and haven't seen anything bad (it’s not
> written by me).
> Recompile with Qt 4.8 didn't help too.
> Any suggestions what could be wrong?
**************** CAUTION - Disclaimer *****************
This e-mail contains PRIVILEGED AND CONFIDENTIAL INFORMATION intended solely
for the use of the addressee(s). If you are not the intended recipient, please
notify the sender by e-mail and delete the original message. Further, you are not
to copy, disclose, or distribute this e-mail or its contents to any other person and
any such actions are unlawful. This e-mail may contain viruses. Infosys has taken
every reasonable precaution to minimize this risk, but is not liable for any damage
you may sustain as a result of any virus in this e-mail. You should carry out your
own virus checks before opening the e-mail or attachment. Infosys reserves the
right to monitor and review the content of all messages sent to or from this e-mail
address. Messages sent to or from this e-mail address may be stored on the
Infosys e-mail system.
***INFOSYS******** End of Disclaimer ********INFOSYS***
-------------- next part --------------
An HTML attachment was scrubbed...
More information about the Interest