[Interest] Odd error using QSerialPort with hardware flow control

[Denis Shienkov]

Hi,

I have not this issue.

* QtSerialPort from the 5.6 branch
* Windows 10
* On-board serial port (where the pins 2-3, 7-8 are connected)
* The Terminal example

Please provide a minimal example which reproduces this issue (also give 
more info about your serial port type).

BR,
Denis

23.10.2015 22:28, Michael R Nelson пишет:
> Hi,
>
> When using offline install of Qt 5.5.1 QSerialPort in Windows7/64bit, if I set the hardware flow control flag, errors are signaled on most port operations (e.g., open, read, and write). The error type is QSerialPort::UnsupportedOperationError, and the error string is "The parameter is incorrect." This only occurs if the hardware flow control flag is set, i.e., m_serialPort->setFlowControl(QSerialPort::HardwareControl).
>
> Have others run into this? Have any work-arounds been identified?
>
> Thanks,
> Mike
>
>
> Please be advised that this email may contain confidential information. If you are not the intended recipient, please notify us by email by replying to the sender and delete this message. The sender disclaims that the content of this email constitutes an offer to enter into, or the acceptance of, any agreement; provided that the foregoing does not invalidate the binding effect of any digital or other electronic reproduction of a manual signature that is included in any attachment.
> _______________________________________________
> Interest mailing list
> Interest at qt-project.org
> http://lists.qt-project.org/mailman/listinfo/interest