[Qbs] Qbs 1.23.2 released

[Карелин Павел]

24.10.2022 17:28, Christian Kandeler via Qbs пишет:
> On 10/24/22 16:15, Карелин Павел wrote:
>>
>>
>> 24.10.2022 16:58, Christian Kandeler via Qbs пишет:
>>> On 10/24/22 15:38, Карелин Павел wrote:
>>>>
>>>>
>>>> 24.10.2022 13:48, Christian Kandeler via Qbs пишет:
>>>>> On 10/24/22 12:34, Карелин Павел wrote:
>>>>>> I think runpath is wrong for libqbscore.so.1.23.2: instead of 
>>>>>> '$ORIGIN/../lib/qtcreator' it should be 
>>>>>> '$ORIGIN/../../lib/qtcreator'
>>>>>>
>>>>> Why? bin/ and lib/ are located on the same level.
>>>> Because loading the libqbsscriptengine.so.1.23 library comes from 
>>>> libqbscore.so.1.23.2, not bin/qbs.
>>>> I conducted an experiment: in the libqbscore.so.1.23.2 I replaced 
>>>> runpath from '$ORIGIN/..:$ORIGIN/../lib/qtcreator:/opt/qt515/lib' 
>>>> to '$ORIGIN/../../lib/qtcreator:/opt/qt515/lib:/usr/bi'
>>>> And everything worked for me.
>>>>
>>> The problem seems to be differences in linker behavior. My binaries 
>>> have RPATH set, yours use RUNPATH. The former works recursively, the 
>>> latter doesn't. What linker are you using? I have binutils 2.39.
>> Systerm compiler from Ubuntu 20.04. GCC version 9.4.0
> That doesn't answer the linker question.
binutils 2.34-6ubuntu1.3

>> In my qbs projects, I explicitly use RPATH instead of RUNPATH using 
>> the following command:
>
>> cpp.driverLinkerFlags: [
>>         "-Wl,--disable-new-dtags",
>>     ]
>
> My man page says:
>
>   By default, the new dynamic tags are not created.
In my man it says the same thing:

man ld
      --enable-new-dtags
      --disable-new-dtags
           This linker can create the new dynamic tags in ELF. But the 
older ELF systems may not understand them. If you specify 
--enable-new-dtags, the new dynamic tags will be created as needed and 
older dynamic tags will be omitted.  If you specify --disable-new-dtags, 
no new dynamic tags will be created. By default, the new dynamic tags 
are not created. Note that those options are only available for ELF systems.

But in fact, the default uses runpath. I ran into this problem when I 
switched to Ubuntu 20.04, and therefore began to use 
"-Wl,--disable-new-dtags".

I rebuild QtC8 with "-Wl,--disable-new-dtags". Now QtC/QBS works fine 
(the crutch is turned off, verified :)))

--
Pavel

>
>
> Christian
>
> _______________________________________________
> Qbs mailing list
> Qbs at qt-project.org
> https://lists.qt-project.org/listinfo/qbs

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.qt-project.org/pipermail/qbs/attachments/20221024/f126e1da/attachment.htm>