[Qt-creator] Start binary without going through build process again

[Liebe Markus (RtP2/TEF72)]

Hi,

At the moment qtcreator always runs make before it starts the application when I run the application.
I think that is quite annoying since I do not always want to run through each Makefile before my application gets started.
On my system and project it takes about 10secs for running through the Makefiles even If I made no changes after the last run.

Is there a way to tell qt creator to just start the configured application and to not run make each time I press "run"?

Mit freundlichen Grüßen / Best regards

Markus Liebe

Robert Bosch GmbH
Automotive Electronics, RtP2/TEF72
Postfach 13 42
72703 Reutlingen
GERMANY
www.bosch.com<http://www.bosch.com>

Tel. 07121 35-35246
markus.liebe at de.bosch.com<mailto:markus.liebe at de.bosch.com>

Sitz: Stuttgart, Registergericht: Amtsgericht Stuttgart, HRB 14000;
Aufsichtsratsvorsitzender: Hermann Scholl; Geschäftsführung: Franz Fehrenbach, Siegfried Dais;
Bernd Bohr, Rudolf Colm, Volkmar Denner, Gerhard Kümmel, Wolfgang Malchow, Peter Marks,
Peter Tyroller; Uwe Raschke



-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.qt-project.org/pipermail/qt-creator-old/attachments/20090508/c9e6ed55/attachment.html