[Qt-creator] Start binary without going through build process again

[Eike Ziller]

On May 8, 2009, at 9:04 AM, ext Liebe Markus (RtP2/TEF72) wrote:

> Hi,
>
> At the moment qtcreator always runs make before it starts the  
> application when I run the application.
> I think that is quite annoying since I do not always want to run  
> through each Makefile before my application gets started.
> On my system and project it takes about 10secs for running through  
> the Makefiles even If I made no changes after the last run.
>
> Is there a way to tell qt creator to just start the configured  
> application and to not run make each time I press "run"?

As of yesterday the nightly snapshots give you the option to not build  
before run (settings, "project explorer" category).

Best regards, Eike

-- 
Eike Ziller
Software Engineer
Nokia, Qt Software
Phone  +49 (0)30 6392 3255
Fax    +49 (0)30 6392 3256
E-mail eike.ziller at nokia.com