[QtonPi] Qt Creator - selecting qmake binary

[Jonathan Mullins]

Thanks Etienne.. some progress it seems, now the error message reports "The default mkspec symlink is broken". Any other tips?

 Cheers

----- Original Message -----
From: Etienne H.
Sent: 09/03/12 06:18 PM
To: Jonathan Mullins
Subject: Re: [QtonPi] Qt Creator - selecting qmake binary

 Hi Jonathan,

 I had the same issue on my system.
 As it turns out, Qt Creator expects a bin/ directory to exist on your target installation directory.
 A simple mkdir /mnt/your_rpi_filesystem/qt5-install-dir/bin should do the trick.

 Hope this helps,
 Etienne

 2012/9/3 Jonathan Mullins < j.mullins at gmx.com >
 Should have mentioned... I'm running Fedora 64 bit.

 Jonathan Mullins < j.mullins at gmx.com > wrote:

 >Hi all,
 >
 >I've managed to complete all the instructions on the beginner's guide >http://qt-project.org/wiki/RaspberryPi_Beginners_guide  to build QT for

 >Pi. When I attempt to configure Qt Creator to use the qmake binary
 >located in /usr/local/qt5pi/bin however, I reports that "Qt version is
 >not properly installed, please run make install".
 >
 > Any suggestions?
 >
 > Cheers, Jono >_______________________________________________
 >QtonPi mailing list
 > QtonPi at qt-project.org 
 >http://lists.qt-project.org/mailman/listinfo/qtonpi 

 --
 Sent from my Android phone with K-9 Mail. Please excuse my brevity.
 _______________________________________________
 QtonPi mailing list
 QtonPi at qt-project.org 
http://lists.qt-project.org/mailman/listinfo/qtonpi
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.qt-project.org/pipermail/qtonpi/attachments/20120903/f61363d0/attachment-0001.html