[Development] Boot to Qt Device problem.

[Dominik Holland]

Hi,

Am 07/20/2016 um 03:41 PM schrieb Bahadır Can:
> Hello Qt Developers Team,
> 
> 
> I am currently working on a Sabre Automative Board with i.MX6Quad. I
> just started to use Qt Embedded . 
> 
> 
> I am following this guide :
> 
> 
> http://doc.qt.io/QtForDeviceCreation/qtee-preparing-hardware-imx6sabresd.html
> 
> 
> I insterted a clean SD card to my device and run the flash boot to Qt
> Device. (with the option Sabre SD i.MX6Quad)
> 
> 
> After installation of image finished. I inserted SD card  to Board and
> restarted the board but nothing happened. (Terminal and screen didn't work.)

That could be related to an too old uboot version. It's probably a good
idea to update the uboot on the board using the instructions here:

http://doc.qt.io/QtForDeviceCreation/qtee-preparing-hardware-imx6.html

Dominik

> 
> 
> I also tried it with a beaglebone black but got nothing on it too. 
> 
> 
> Am I missing any steps?
> 
> 
> Thanks from now.
> 
> 
> Bahadır
> 
> Preparing SABRE SD i.MX6Quad | Qt 5.7 for Device Creation
> <http://doc.qt.io/QtForDeviceCreation/qtee-preparing-hardware-imx6sabresd.html>
> doc.qt.io
> Take the following steps to prepare Freescale SABRE SD i.MX6Quad for
> Boot to Qt: Note: It is important that you repeat the steps in this
> section after you update Qt ...
> 
> 
> 
> 
> 
> _______________________________________________
> Development mailing list
> Development at qt-project.org
> http://lists.qt-project.org/mailman/listinfo/development
> 

-- 
Dominik Holland
SENIOR SOFTWARE ENGINEER

Pelagicore AG
Balanstr. 55, 81541 Munich, Germany
+49 (0)171 760 25 96
dominik.holland at pelagicore.com
www.pelagicore.com